分配泵拆卸的7个窍门

译文：
分配泵拆卸的7个窍门： 1、可拆可不拆的零件尽量不拆。分配泵在运转时，要用小油盘承接流出的柴油。 2、拆卸油泵转子时，一定要顺着分配转子旋转的方向才能拆下，拆时要用专用扳手。 3、分配泵转子右端中间的小螺钉，是加工中心油道时的工艺孔闷塞，一般不拆。 4、正时环不要拆凸轮圈，因为它是靠本身的弹性固定在守则体内，出厂时定位已校正好，拆后不易校准。 5、拆花键套与前后控制板时，应注意它原来的装配位置，以便装复。只有调整最大供油量时，才允许稍微转动前后控制板。 6、调压阀总成如无故障不要拆卸，如果必须拆卸时，应注意调压阀弹簧不要丢失，按原来装回。 7、在拆三角接盘时，应在连接处打一记号，以便安装时按记号装复。

“ Distribution pump demolished 7 Tips ”是由中国磁力泵网提供的国际水泵新闻，译文仅供参考。另外，中国磁力泵网还提供相关产品搜索：磁力泵型号、磁力泵价格、磁力泵技术、磁力泵新闻、磁力泵生产商等。

原文：
Distribution pump demolished seven tips: 1, removable parts as possible from time to dismantle the old one. Distribution of the pump is running, useMagnetic Pumps the small oil pan carry out the diesel. 2, dismantling pump rotor, be sure to follow the distribution of the direction of rotation of the rotor can be removed during demolition to use special wrench. 3, distribution of the right end of the middle of the small pump rotor screw is the oil processing center hole boring process when Road congestion is generally not removed. 4, are not removed when the cam CQF Series Magnetic Drive Pumpring ring, because it is fixed by its own elastic body in the code, locate the factory calibrated well, after the split is not easy calibration. 5, before and after demolition spline sets and control panels should pay attention to the assembly of its original location to install complex. Only adjust the maximum fuel supply, the only allowed to turn a little before and after the control panel. 6, the dump valve assemblyFluoroplastic Magnetic Pumps should not be demolished without fault, if you must disassemble, regulators should pay attention not to lose the spring, according to the original installation back. 7 pick in the demolition of triangular plate, the junction should be a mark for installation by sign refitted.